Now Is The Time Replace Window Weatherstripping Before Winter
Prepare Your Windows for Winter with Fresh Weather Seals
Cold air slipping around a window can make a room feel uncomfortable and may lead you to turn up the heat. A worn, compressed, or damaged weather seal can leave gaps between the window and frame. Replacing it before winter is a practical way to improve the seal and make your home feel more comfortable.
How to Spot a Worn Window Seal
Check the edges of closed windows for visible gaps, cracked or flattened foam, peeling adhesive, or sections that have come loose. On a windy day, you may notice a draft near the frame. You can also inspect the area for dust or debris collecting along the edges, which may point to air movement.
Before replacing anything, make sure the window is fully closed and latched. Some drafts come from a window that is not seated properly, rather than from worn weatherstripping.
Choose a Seal That Fits the Gap
Weather seals come in different materials, widths, thicknesses, and profiles. Foam strips are a common option for small gaps around windows, while other sealing products may suit different surfaces or conditions. The best choice depends on the size of the gap, how the window opens, and the surface where the seal will attach.
- Measure first: Check the length of each area that needs sealing and estimate the gap when the window is closed.
- Consider compression: The seal should make contact when the window closes without preventing it from latching or operating smoothly.
- Check the surface: Adhesive-backed products need a clean, dry surface for a secure application.
- Match the location: Choose a product intended for the window area and conditions where it will be used.
Replace Window Weatherstripping Step by Step
- Inspect the window: Identify worn sections and note where the sash meets the frame. Avoid covering drainage openings or hardware.
- Remove the old seal: Peel or lift away the existing material carefully. Clear away residue without damaging the frame or finish.
- Clean and dry: Remove dust and dirt from the application area, then let the surface dry fully.
- Cut to fit: Measure each section and cut the replacement strip to length before removing its backing.
- Apply evenly: Press the seal into place along the intended contact area. Keep it straight and avoid stretching the material.
- Test the window: Close and open it to confirm that it latches and moves as expected. Adjust the seal if it bunches or makes the window difficult to close. Special Note: Acrylic PSA is best for making adjustments, our Rubber PSA has immediate tack and is nearly impossible to reposition once applied!
Common Mistakes to Avoid
Using a seal that is too thick can make a window hard to close or put pressure on the frame. Applying adhesive over dirt or moisture can also reduce how well it stays attached. Take time to measure, prepare the surface, and test the window before sealing every side.
Weatherstripping is not a substitute for repairing damaged frames, loose glazing, or other structural problems. If you find signs of water intrusion, rotting material, or a window that will not close properly, address those issues as well.
A Simple Seasonal Check
Inspect window seals before cold weather arrives and again when you notice drafts or visible wear. Replacing damaged sections promptly can help keep the window area more comfortable through the season. With the right measurements and a suitable foam strip or sealing product, a small maintenance task can make a noticeable difference in how well your windows close.
Leave a comment